Jlg 340AJ Service Manual User Manual Page 79

  • Download
  • Add to my manuals
  • Print
  • Page
    / 348
  • Table of contents
  • TROUBLESHOOTING
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 78
SECTION 3 - CHASSIS & TURNTABLE
3121259 – JLG Lift – 3-39
10. Place rotor set (8) and wear plate (9) on a flat surface and
center rotor in stator such that two rotor lobes (180
degrees apart) and a roller vane centerline are on the
same stator centerline. Check the rotor lobe to roller
vane clearance with a feeler gage at this common cen-
terline. If there is more than 0.005 inches (0.13 mm) of
clearance, replace rotor set.
NOTE: If rotor set (8) has two stator halves and two sets of seven
vanes as shown, check the rotor lobe to roller vane clear-
ance at both ends of rotor.
11. Remove drive link (10) from coupling shaft (12) if it was
not removed with rotor set and wear plate. Inspect drive
link for cracks and worn or damaged splines. No percep-
tible lash (play) should be noted between mating spline
parts. Remove and discard seal ring (4) from housing
(18).
12. Remove thrust bearing (11) from top of coupling shaft
(12). Inspect for wear, brinelling, corrosion and a full
complement of retained rollers.
13. Check exposed portion of coupling shaft (12) to be sure
you have removed all signs of rust and corrosion which
might prevent its withdrawal through the seal and bear-
ing. Crocus cloth or fine emery paper may be used.
Page view 78
1 2 ... 74 75 76 77 78 79 80 81 82 83 84 ... 347 348

Comments to this Manuals

No comments