Jlg 1350SJP Service Manual User Manual Page 483

  • Download
  • Add to my manuals
  • Print
  • Page
    / 554
  • Table of contents
  • TROUBLESHOOTING
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 482
SECTION 6 - JLG CONTROL SYSTEM
3121142 – JLG Lift – 6-107
9941 99 41 CHASSIS SENSOR SUPPLY OUT OF RANGE LOW The Chassis Sensors supply volt-
age is low.
9942 99 42 BLAM BACKUP COMMUNICATIONS LINK FAULTY The BLAM backup communica-
tions link test was activated at
startup, but no communication
connection established/main-
tained.
- BLAM equipped vehicles only.
-1250
9943 99 43 BLAM BACKUP COMMUNICATIONS LOST - HYDRAULICS SUSPENDED The BLAM backup communica-
tions link was activated, but no
communication connection
established/maintained.
- BLAM equipped vehicles only.
-1250
9944 99 44 CURRENT FEEDBACK GAINS OUT OF RANGE The factory set current feedback
gains are out of range.
9945 99 45 CURRENT FEEDBACK CALIBRATION CHECKSUM INCORRECT The factory set current feedback
checksum is not correct.
9975 99 75 LOAD PIN NOT CALIBRATED The Load Pin has not been cali-
brated.
-1250
9979 99 79 FUNCTIONS LOCKED OUT - GROUND MODULE SOFTWARE VERSION
IMPROPER
Temporary fault for the telemat-
ics project. The model needs to
be a 600S or 1350S if not this
fault will be generated and Plat-
form co nt ro ls wi ll b e pre ve nted .
This fault was to insure that the
software will only work for
these two models.
Table 6-6. Diagnostic Trouble Code Chart
DTC
Flash
Code
Sequence
Fault Message Fault Description Check
Page view 482
1 2 ... 478 479 480 481 482 483 484 485 486 487 488 ... 553 554

Comments to this Manuals

No comments