Jlg 1350SJP Service Manual User Manual Page 403

  • Download
  • Add to my manuals
  • Print
  • Page
    / 554
  • Table of contents
  • TROUBLESHOOTING
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 402
SECTION 6 - JLG CONTROL SYSTEM
3121142 – JLG Lift – 6-27
6.10 MACHINE ORIENTATION WHEN SETTING
FUNCTION SPEEDS
Lift Up: From platform control, lowest elevation up to maxi-
mum elevation, boom retracted.
Lift Down: From platform control, maximum elevation down
to minimum elevation, boom retracted.
Swing Right (Max): 360 Degrees, from platform control, boom
approximately 45° elevation, boom retracted.
Swing Left (Max): 360 Degrees, from platform control, boom
approximately 45° elevation, boom retracted.
Telescope Out: From platform control, boom horizontal, 500
lb. (230 kg) capacity selected.
Telescope In: From platform control, boom horizontal, 500 lb.
(230 kg) capacity selected.
Drive Forward (Max): Test should be done on a smooth level
surface. High Speed - Low Torque setting, drive 200 ft. (61 m)
front wheels to front wheels. Timed after machine has
obtained maximum speed.
Drive Reverse (Max): Test should be done on a smooth level
surface. High Speed - Low Torque setting, drive 200 ft. (61 m)
front wheels to front wheels. Timed after machine has
obtained maximum speed.
Drive Forward (Creep Max): Test should be done on a
smooth level surface. High Torque - Low Speed setting, plat-
form speed knob at full creep.
Drive Reverse (Creep Max): Test should be done on a smooth
level surface. High Torque - Low Speed setting, platform speed
knob at full creep.
Drive Forward (Elevated Max - Boom Beyond Transport):
Test should be done on a smooth level surface. High speed -
Low Torque setting, platform speed knob out of creep, Lift
boom above transport, drive forward 50 ft. (15.2 m).
Drive Reverse (Elevated Max - Boom Beyond Transport):
Test should be done on a smooth level surface. High speed -
Low Torque setting, platform speed knob out of creep, Lift
boom above transport, drive forward 50 ft. (15.2 m).
Platform Rotate: Platform level and completely rotated one
direction. Rotate the opposite direction, Record Time. Rotate
the other direction, Record Time.
Articulating Jib: Platform level and centered with the boom.
Start with the Jib down. Jib Up, Record Time. Jib Down, Record
Time.
Test Notes
1. Personality settings can be adjusted anywhere within
the adjustment range in order to achieve optimum
machine performance.
2. Stop watch should be started when the function is acti-
vated.
3. Unless noted, all speed tests are run from the platform.
These speeds do not reflect the ground control opera-
tion.
4. The platform speed knob control must be at full speed
(turned clockwise completely).
5. Function speeds may vary due to cold, thick hydraulic
oil. Test should be run with the oil temperature above
100° F (38° C).
Page view 402
1 2 ... 398 399 400 401 402 403 404 405 406 407 408 ... 553 554

Comments to this Manuals

No comments