Operation & SafetyManualOriginal InstructionsKeep this manual with machine at all times.An Oshkosh Corporation CompanyTelehandlerPersonnel Work Pl
Section 1 - General Safety Practices1-2 312001601.2 GENERAL PRECAUTIONS• DO NOT use the telehandler with platform attached for any purpose other thanp
1-3312001601.3 OPERATION SAFETYElectrical Hazards• This machine is not insulated and does not provide protection from contact orproximity to electrica
Section 1 - General Safety Practices1-4 31200160Tip Over Hazard• DO NOT exceed rated lift capacity. Distribute loads evenly on platform floor.• Be sur
Section 1 - General Safety Practices1-531200160• USE ONLY an approved personnel work platform.• DO NOT drive machine from cab when personnel are in pl
Section 1 - General Safety Practices1-6 31200160Load Falling Hazard• Never suspend load from platform or supports.• DO NOT carry materials directly on
Section 1 - General Safety Practices1-731200160Pinch Points and Crush HazardsStay clear of pinch points and rotating parts on the telehandler.• Stay c
Section 1 - General Safety Practices1-8 31200160• Keep arms and hands clear of attachment tilt cylinder.• During operation, keep all body parts inside
Section 1 - General Safety Practices1-931200160Fall Hazard• During operation, occupants in the platform must wear a full body harness with alanyard at
Section 1 - General Safety Practices1-10 31200160• Never tilt the platform when the platform is occupied.OAB0160
Section 1 - General Safety Practices1-1131200160Chemical HazardsExhaust Fumes• DO NOT operate machine in an enclosed area without proper ventilation.•
CALIFORNIA PROPOSITION 65BATTERY WARNINGBattery posts,terminals and relatedaccessories containlead and lead compounds,chemical known to theState of Ca
Section 1 - General Safety Practices1-12 31200160This Page Intentionally Left Blank
Section 2 - Pre-Operation and Inspection2-131200160SECTION 2 - PRE-OPERATION AND INSPECTION2.1 PRE-OPERATION CHECK AND INSPECTIONNote: Complete all r
Section 2 - Pre-Operation and Inspection2-2 312001602.2 SAFETY DECALS - JLG SUPPLIED PERSONNEL WORK PLATFORMEnsure all DANGER, WARNING, CAUTION and
Section 2 - Pre-Operation and Inspection2-331200160S/N 2006058-01 & AfterOAB0090170150917015091704277 B170427717068921706892AAll occupants must we
Section 2 - Pre-Operation and Inspection2-4 31200160Fork MountedOAB01921704277 B17042771707063170150917015091001092482AOperator and occupantsmust read
Section 2 - Pre-Operation and Inspection2-5312001602.3 WALK-AROUND INSPECTIONBegin your platform walk-around inspection at item 1, as noted below. Con
Section 2 - Pre-Operation and Inspection2-6 312001602.4 WARM-UP AND OPERATIONAL CHECKSWarm-Up CheckWarm-up and operational checks of the telehandler a
Section 3 - Operation3-131200160SECTION 3 - OPERATION3.1 PLATFORM OPERATION• JLG recommends the user comply with local, provincial and federal regulat
Section 3 - Operation3-2 312001603.2 USE OF THE CAPACITY CHARTExampleA contractor owns a model xxxxx telehandler with a 48" Carriage. He knows hi
Section 3 - Operation3-331200160Note: This is a sample capacity chart only! DO NOT use this chart, use the one located in your operator cab.XXXXXXXX4
Revision Loga31200160Revision LogREVISION LOGJanuary 2, 2007 - A - Original Issue of ManualMarch 22, 2007 - B - Revised pages 3-1, 4-4 and 6-1.Februar
Section 3 - Operation3-4 312001603.3 LOADING AND SECURING FOR TRANSPORT1. If attached to telehandler, refer to the Operation & Safety Manual suppl
Section 4 - Types of Personnel Work Platforms4-131200160SECTION 4 - TYPES OF PERSONNEL WORK PLATFORMS4.1 APPROVED PERSONNEL WORK PLATFORMSQuick Switch
Section 4 - Types of Personnel Work Platforms4-2 312001604.2 UNAPPROVED PERSONNEL WORK PLATFORMSDo not attach any type of personnel work platform that
Section 4 - Types of Personnel Work Platforms4-3312001604.3 PLATFORM INSTALLATIONQuick Switch Mounted - JLG SuppliedVerify the personnel work platform
Section 4 - Types of Personnel Work Platforms4-4 31200160• Attachment pin engaged in platform pin recess. Lock pin engaged fully andsecured with retai
Section 5 - Emergency Procedures5-131200160SECTION 5 - EMERGENCY PROCEDURES5.1 EMERGENCY LOWERING OF BOOMIn the event of total loss of engine power, h
Section 5 - Emergency Procedures5-2 31200160This Page Intentionally Left Blank
Section 6 - Specifications6-131200160SECTION 6 - SPECIFICATIONS6.1 PRODUCT SPECIFICATIONS - JLG SUPPLIED PERSONNEL WORK PLATFORMFor telehandler specif
Section 6 - Specifications6-2 31200160This Page Intentionally Left Blank
Index131200160CCapacity Chart... 3-2Example... 3-2Chemical Hazards...
Read This Firstb 31200160Read This FirstThis manual is a very important tool! Keep it with the machine at all times.The purpose of this manual is to p
Index2 31200160
Inspection, Maintenance and Repair LogSerial Number ______________________________Date CommentsInspection, Maintenance and Repair Log
Inspection, Maintenance and Repair LogDate Comments
Hand SignalsSpecial Signals - When signals for auxiliary equipment functions or conditions not covered are required, they shall be agreed upon in adva
JLG Industries, Inc.1 JLG DriveMcConnellsburg PA. 17233-9533USAPhone: +1-717-485-5161Customer Support Toll Free: 1-877-554-5438Fax: +1-717-485-6417JLG
Read This Firstc31200160This product must comply with all safety related bulletins. Contact JLG Industries,Inc. or the local authorized JLG representa
Read This Firstd 31200160This Page Intentionally Left Blank
Table of Contentsi31200160TABLE OF CONTENTSRevision LogRead This FirstTelehandler Operator and PlatformOccupant Qualifications ...
Table of Contentsii 31200160Section 4 - Types of Personnel Work Platforms4.1 Approved Personnel Work Platforms ... 4-1Q
Section 1 - General Safety Practices1-131200160SECTION 1 - GENERAL SAFETY PRACTICES1.1 HAZARD CLASSIFICATION SYSTEMSafety Alert System and Safety Sign
Comments to this Manuals